How to make a wall of drywall?

Sometimes the layout of the room does not suit the hosts, and they tend to divide them into several smaller rooms. It is not necessary to erect buildings made of bricks and concrete, cumbersome structures may well replace the partition of gypsum board . In this example, you will learn how to properly perform the work on the arrangement of such a wall from this excellent material.

How to make a wall of drywall yourself:

1. The inner frame is best made of galvanized profile, it is sturdy and withstands loads that can arise during the operation of our wall.
2. In some places, sometimes it is necessary to strengthen the frame, for this purpose the wooden beam perfectly fits.
3. Gypsum board we take for work thickness of 12.2 mm.
4. The tool is the most common - screwdriver, level, tape measure, screws, metal scissors, plumb and laser level.
5. We screw to the floor profile self-tapping screws.
6. Vertical profile to the wall of a brick or foam block is fastened with dowels-nails after 30-40 cm.
7. In the case, how to make a strong interior wall of drywall, you need to do everything carefully. We join the joints of the profile with short self-tapping screws.
8. The guiding profile at us goes on all perimeter of the future wall.
9. From this material we form a doorway. Cut the profile of the desired size and attach it to the guides. The width of the opening must coincide at the top and bottom, so all work is controlled by the level.
10. Increase the strength of the opening can be wooden blocks inserted into the profile.
11. At the top and bottom we screw the posts to the frame with self-tapping screws 35 mm in length. In the case, how to make a false wall of gypsum board, this fixing material is used in large quantities, so take care that it is stocked with enough to work.
12. We install the other rack-mount profiles. Their number depends on the width of the room and the size of the drywall. One sheet usually requires 3 vertical racks. The marking step is 60 cm and the width of the plasterboard is 120 cm.
13. We connect the neighboring racks with pieces of the profile to increase the rigidity of the frame.
14. In the place of the opening, the cross-section billets are fixed horizontally and strictly along the marks.
15. The quality of work is verified by a square.
16. A very important advice for those who want to learn how to properly make a wall from gypsum board - in the place where you plan to install shelves or hooks, you need to install on the frame mortgages from the bars.
17. For soundproofing, fill the inside of the structure with mineral wool.
18. From below we provide a gap, substituting under the cardboard special thin slats.
19. We fix the plasterboard to the frame, slightly drowning the screws for about 1 mm into the depth of the sheet.
20. The step between the screws is 15-20 cm.
21. We install the remaining sheets of cardboard on both sides, completely sewing them frame. The partition is ready, you can start finishing work.