Locks from the face

Hairstyles with curls are a great variety and, unsurprisingly, they do not lose popularity. Drooping from the face of the locks create an additional volume, and also give the image some lightness, romanticism. There are a lot of tools that you can use to create ringlets:

Let's consider some ways to make such packing relatively quickly.

Who will fit the styling with the curls from the face?

For this styling, the face oval does not really matter, but there are certain tricks:

  1. So, for the oval face, the curls will look no matter where they start, but when laying on short hair it is better to curl them outward, from the face, otherwise the face can visually stretch out, seem narrower.
  2. For the round face, curls on medium and long hair look good, but the curls that frame the face are best avoided, since they make it even wider.
  3. For a square face, large, flowing curls are most suited, but one should not make curls around the chin and cheekbones.
  4. For a triangular type of face, it is optimal when curls begin from the line of cheekbones and below.

How to make curls from the face ironing?

To create a curl, the iron is suitable, which heats up from all sides and has rounded ends:

  1. Hair comb and divide into strands.
  2. The iron must be perpendicular to the locks of the hair. End the strand with a straightener and wind on the iron in the desired direction.
  3. Pull the forceps down smoothly. The result is a slightly straightened, large curl.

How to make curls from the face of a curling iron?

It is preferable to use a ceramic-coated plaque, it is more careful with hair:

  1. For winding take small, no thicker little finger, strands, otherwise they will not warm up.
  2. Plaiting is usually used to produce large enough ringlets, but the thinner the strand is taken, the smaller and more frequent curls are obtained.
  3. Withstand each strand from 20 to 40 seconds, depending on how tight the hair is.
  4. Twist the strand on a curling rod, usually in a spiral, from the tips to the roots.

Any laying is done on pre-washed and dried hair, possibly using special tools designed for thermal bonding. Use the fixing means after the piling is finished, or in the process, for each individual strand.