MDF - an excellent basis for facing the room, allowing you to create a stylish and modern interior design.
Preparatory work for the installation of MDF panels
The principle of operation is very simple.
- The work on the installation of MDF panels on the walls begins with the device of a wooden crate. For rooms with high humidity it is better to use a lath made of metal profiles.
So, you need a beam of 20x40 mm. He "put" on the screws with a screwdriver. The length of the strips will be 40-50 cm. The installation of MDF panels on the wall with glue is not a reliable method.
For high-quality mounting, you must always check the verticality and levelness of the levels. If you deviate by level, you can put a bar, plywood or construction wedge. Fixation is made by a long screw or dowel-nail, depending on the type of the supporting structure. Check the level again.
- MDF panels are not attached until all the crate is ready. From the floor, retreat to 5 cm, this will simplify the installation of the finishing floor covering with a skirting board. Reiki should be along the perimeter of all window and door openings.
Wall cladding with MDF panels: mounting technology
- Mounting MDF elements begins at the corner of the room. Through the entire height the panel is fixed with self-tapping screws to the crate.
- The subsequent panels to each other and under the construction are fixed by means of bracket-clayers. This hardware is inserted into the groove of the panel and fixed with a construction stepper. For reliability, a nail is hammered. Do not damage the edge of the finish. For this, it is convenient to use pliers. (
- Further into the groove of the panel, the comb of the next element is started, again we become attached to the crate. Work is carried out in a similar way, proceed to the new wall from the corner.
- Cutting material is carried out by a saw on a tree and an electric jigsaw.
- When the walls are finished, it is necessary to cover the corners with special MDF fittings. A folding corner is glued to the joint. After applying glue, the rack is pressed against the corner.
We get:
MDF finishing allows you to get such an interior: