The desire for comfort and convenience moves the progress of progress. Once the remote control of the TV seemed almost a miracle. Now it is not considered rare to install a switch with remote control.
How is the light switch with the remote control?
The whole device consists of the remote switch itself, the receiving unit in it and one remote control. The device provides the ability to control light from a distance in your home. Chandelier or lamp reacts to the radio signal, which comes from the console. Inside the mechanism is a steel core with a coil. After pressing the power button, the coil receives power. Due to this, the core starts to move, closing electrical contact.
The range of the remote control is about 5-15 m. The remote light switch with a street controller is capable of giving a signal up to 100 m.
Advantages of the remote switch a lot. Now you can turn off the lamp without getting out of bed. Especially this function is relevant for people with disabilities. More than that, the remote switch is easy to use and easy to install.
The offers of remote switches in specialized stores are many. For example, the Belarusian device "Sapphire" is equipped with a brightness regulator, which significantly extends the life of lamps. Remote switch Wookee - another quality representative, equipped with a special holder and two switches for individual networks. For any design, you can choose from stylish models from Jung.
Remote switch connection
Connect switches with remote switches in different ways, depending on which light in the fixture. For incandescent lamps, the connection is similar to the installation of a conventional switch.
If the chandelier is a light-emitting diode or energy-saving lamp, for normal operation the device can not do without the presence of zero and phase. If you turn off the electricity in the house in the shield, determine the zero and phase wires on the wires. In place of the old switch on the wall, you need to secure the signal receiving unit. Next, the common wire from the ceiling is connected to the phase conductor to generate a voltage. These wires are connected to the input terminals of the unit. And the third wire is connected to the output terminal. By the way, there are blocks that are installed inside the luminaire. However, the connection diagram of the remote light switch with the remote control is the same.
