Hardware face cleaning is a convenient alternative for those who do not have the skills of a cosmetologist and are afraid to do the procedures for cleansing the person themselves. Today there are three hardware procedures that have their pros and cons:
- Ultrasonic cleaning of the face. This is the very first hardware cleaning method that was used in cosmetology.
- Vacuum cleaning of the face. This method can not clean the deepest dirt, but it is very effective for cleaning the surface layers.
- Galvanic cleaning. It, as well as vacuum cleaning, does not have a strong effect on the deep layers of the dermis, however, to clean the surface contamination is capable.
Ultrasonic face cleaning
Scrubber is a device for ultrasonic cleansing of the face, which is considered to be the deepest and most effective. During ultrasonic cleaning, short waves are applied to the face, which penetrate deeply into the dermis and make micromassage of tissues. At the same time all the skin from inside is revitalized and renewed.
Indications:
- Clogged pores.
- Non-inflammatory acne.
Ultrasonic cleaning of the face, in addition to its main effect - cleansing, is able to smooth out fine wrinkles. Therefore, it is recommended to use it regularly for girls after 25 years.
Preparation:
- First, the beautician cleanses the skin of contaminants, removing make-up. For this, conventional cosmetics suitable for the skin type are used.
- Then the specialist applies a special lotion on the skin, which will help the dead cells to peel off when exposed to ultrasound.
Ultrasonic cleaning
When the face is prepared, the cosmetologist drives the end of the scrubber over the face: at this time the dead horny layer of skin peels off and out of the open pores come out the contaminants: the remains of make-up and the dust that clogged the pores.
During the procedure, the fat content of the skin decreases, and therefore the owners of dry skin should use the nourishing cream after completion.
The number of procedures directly depends on how crowded the pores and the number of comedones. Each procedure does not take more than 15 minutes and is painless.
Vacuum cleaning of face
Vacuum cleaning of the face uses a device with a special tube, which draws out contaminants. This is a fairly simple and absolutely painless procedure, requiring minimal preparation. After it, the skin does not remain reddening, and its appearance only improves: the complexion, due to increased blood supply to the upper layers of the dermis, the flabbiness disappears due to toning.
This procedure is useful not only for problem skin, but also for normal: it can serve as a preventive measure against early aging.
Indications:
- Contaminated pores.
- Acne is not a stage of inflammation.
Preparation for the procedure:
- First, make-up remover with the help of a means that is suitable for the type of skin.
- Then the cosmetologist uses a vaporizer to open the pores. If the condition of the skin does not allow using this method, then a warming cream is applied to the skin.
Procedure
The apparatus has a suction cup, which the expert applies to the contaminated areas of the skin. It draws dirt, and so this procedure is more suitable for dense oily skin, rather than dry, flabby and thinned.
Galvanic face cleaning
This procedure uses a facial cleanser that has a constant current. But it is so insignificant that it practically does not feel skin. The tension melts the fat, and therefore the contents of the pores easily go out.
Galvanic cleaning is a hardware alternative to manual cleaning, since it cleans only the surface layers of the skin.
Indications:
- Oily skin.
- Comedones.
- Acne.
- Mimic wrinkles.
Preparation:
- First, the specialist cleanses the face.
- Then the cosmetologist applies a special gel to react with the impurities that will act under the influence of current.
Procedure
The apparatus for galvanic cleaning has a nozzle with electrodes, which the expert leads over the skin. Under the influence of current, contaminants are melted and come out, and then react with the applied gel and form a soap foam.
After the procedure, the face is cleaned and a moisturizer is applied.