Ficus Benjamin - reproduction

This type of ficus is a relative of the more common rubber-like ficus. However, you will not see external similarity in these plants. Decorability, a variety of forms and coloring of leaves, unpretentiousness in grooming are the main factors that cause the florists' love for the Benjamin ficus. Thanks to the flexibility of the trunks of this flower, you can create real living masterpieces, including bonsai .

Propagation of Benjamin ficus can be done with seeds, cuttings, cuttings.

Reproduction by seeds

If we compare the existing methods of reproduction of the fig tree of Benjamin, then the most troublesome and lasting is the multiplication by seeds. First, it is necessary to buy seed in stores, where all the conditions of storage of this fastidious goods are observed. Sharp temperature changes, excessive humidity in the room can lead to the fact that the seeds will be spoiled. Acquired seeds of the Benjamin ficus should be treated with a growth stimulant to increase germination. After processing, they can immediately be sown in the ground. Substrate is better to get ready, and before planting it should be properly moistened. Then simply cover the pot or box with the seed glass to create the effect of the greenhouse. Try not to let the temperature in the room below 25 degrees go down.

When the seeds germinate, the greenhouse needs to be opened from time to time. So plants will get used to open space. If the ficus sprouts grew to 4 centimeters, they can already be transplanted into ordinary flower pots.

Reproduction by layers

This method allows you to immediately get large plants, which in height can reach 50 centimeters. To multiply the Benjamin ficus by layers, it is necessary to remove all leaves and shoots from the selected 10-15 cm section of the trunk, which is located not less than 60 centimeters from the top. In addition, you should also remove the bark ring under one of the nodes. Then the treated area should be lubricated with cornevine or heteroauxin. These drugs stimulate the formation of roots. After that, the trunk should be wrapped with moss-sphagnum, pre-moistened, and hidden under a transparent polyethylene, fixing it with adhesive tape or wire. Roots that will grow in a few months is a signal that the leavers are ready to be separated and transplanted into a separate pot.

Reproduction by cuttings

Reproduction of the Benjamin ficus by cuttings is a quick and easy way. Cuttings are cut by a semi-mature shoot, the length of which should be within 10 centimeters. The juice released by the plant must be washed off from the cut so that it does not slow down the process of rooting the cuttings of the Benjamin ficus by drying up. Place the cutting in a vessel with water, cutting the lowest sheet. Adding activated carbon to the water and acetylsalicylic acid tablet, you will save the stalk from decay. Ficuses love light, so the best place for rooting the cut is the window sill on the south side. However, do not forget to replenish its stock in the vessel as the water evaporates. In a month or two your stalk will acquire strong roots and will be ready to be transplanted into a pot.

A variation of propagation of cuttings is the reproduction of the fig tree of Benjamin leaf. For this, a sheet with a small part of the stem is cut from the adult plant by a scythe. Turning it into a tube, planted in the ground through the cutting. In greenhouse conditions, such a sheet in a month will please young leaves and roots.

As you can see, reproduction of the fig tree of Benjamin, like caring for him, does not amount to labor.