LED ceiling lighting

With the advent of stretch ceilings, the possibilities of designers have significantly expanded. Today, it is very unusual to decorate the ceiling with a combination of finishes and light. Backlight stretch ceiling LED strip allows you to create a hidden lighting, which is itself a decor of the room.

Backlight stretch ceiling LED strip: how it works?

In this case, instead of lamps or spotlights, the role of a light source is played by a tape. It is placed behind the stretch film, and the ceiling itself plays the role of a lampshade. It dissipates light and thereby creates soft lighting.

LED ceiling lighting with remote control is not just a fashionable trend in the world of lighting systems. It is quite convenient and practical. With the help of the remote, you can turn on only some sections of the tape and cover only certain sectors in the room. You can change the brightness of the lighting, the hue of the light stream or create smooth color transitions.

The advantage of LED ceiling lighting is in ease of use, durability and low energy consumption. In addition, the tape is fully compliant with the rules of fire safety.

How to make LED ceiling lights?

If you decide to use in the interior of the LED lighting , then you will have to install the ceiling lighting before the ceiling itself is fixed.

1. First, a ceiling tensioner is installed on the wall.
2. Directly to this frame we attach the tape. As a rule, most models have a special adhesive side. The rest is set with clips.
3. Down the cable channel, you need to wire to the power supply. Do this at the stage of wall finishing, so that all the wires can be hidden under the plaster.
4. Remember that the power supply itself must be secured in such a way that it can be reached. This is the serviced part and in due course there may be a need for replacement.
5. It is also necessary to take into account the intensity of illumination. During the installation of LED ceiling lights, the number of LEDs should correspond to the distance from the film to the overlap. If this distance is about 2 cm, it is better not to use the LEDs at all, since overheating is possible.
6. At the end, the concrete overlap is painted white and the film is stretched. Make the lighting of the ceiling LED strip is not so difficult and quite possible for a layman.