Do not start motokosa

During the care of a household plot sometimes people have to face the fact that their motocross does not start. There are several reasons for the refusal of this tool.

Motokosa not start - the reasons

Incorrect storage, long interruption in maintenance, untimely maintenance and other factors lead to the fact that the motor can not start.

Diagnosis of the causes should begin with the verification of the main components - the fuel tank, candles and candle channel, air and fuel filters, breather, exhaust duct. Most of the problems are associated with one of these nodes, and a thorough inspection of them will help determine why the motocross does not start.

If you use poor-quality fuel (below AI-92), this can lead to a breakdown of the cylinder-piston system, the repair of which will result in about a third of the cost of the motorcycle . In addition, it is important to observe the correct ratio of gasoline and oil specified in the operating instructions to your particular model.

The engine can also be prevented from contaminating the fuel filter. If this problem is found, you need to replace the filter. It will not hurt to check the air filter. When it is soiled, it is necessary to disassemble it, rinse it in water with detergents, dry it, lubricate it in oil and put it in its place. Spark plugs, not giving signs of life, need to be replaced with new ones.

Sometimes the brush is started normally, but then stalls. This is mainly due to improper adjustment of the carburetor or its misalignment. Determine that the reason is in this, you can by vibration, which are palpable during work. Adjust the fuel flow adjustment by following the instructions on the tool.

Motokosa badly started on a hot

When the motokosa worked properly, and after a small break does not want to start again, you need to pull the trigger and sharply pull the starter cord several times in a row, until the engine starts and then release the gas trigger.

Motokosa does not start on cold

At the factory of cold motorcycles, it is not recommended to press the gas, on the contrary. It is necessary to tilt the gas pump in such a way that the air filter is at the top and press the suction button 5-6 times, then set the function shift lever to the "Start" position and pull the cord several times until the motor starts. After a few seconds of running the braid, the start system can be turned off.