I want to share with you how to make one of the simplest petals of Kanzash - a sharp petal. I will make a flower of five petals on a hairpin.
Hairpins for Kanzashi hair by hand - a master class
So, in order to make it, we need:
- Satin ribbon width 2.5 cm (I took two kinds of blue and blue.It will look beautiful green with orange, pink and white and yellow with orange);
- hairpins (I needed 5 pieces);
- glue gun;
- glue;
- scissors;
- the basis;
- midpoints for flowers;
- ordinary needle.
Progress:
- First, we prepare the basis for the flower. We need it so that the flower does not come off the hairpin. From the tape cut off the box, and draw a circle in it. The diameter of the circle is 1.5 cm.
- Now we cut it out, and we process the edges with fire (that is, a little cauterized so that the threads do not get out). When all this was done, take the needle and heat it red, and pierce the two holes for the hairpin.
- We put a foundation on the studs so that the wrong side of the base looks up. Apply a little glue between the holes and glue the stud with the base.
- Let's start making petals: cut 25 blue squares and 25 blue squares.
- First we need to make an inner petal (I have a blue one). We take a square and add it so that we have a triangle.
- We add the second time and the third. The third time should be a petal.
- In the place where the corners join, cut off a little (in order that the inner was slightly smaller than the outer petal), then burn and slightly pinch so that the corners are stuck to each other.
- The blue square is also folded into a triangle, but only twice.
- And the fact that we turned out to wrap the blue petal. Everything, the petal is ready.
- We need 25 petals.
- On one side of the petal we carry a little glue and glue the second petal.
- And so on, the third, fourth and fifth.
- It remains to glue the middle. Now we can paste our Kanzash flowers on the studs.
- Our studs are ready!
These hairpins can decorate the hair at the prom , at the wedding and just for every day. Good luck!