Weaving bracelets from laces

Most women are fond of needlework and weaving in particular. Weaving of various ornaments from laces is a process not only fascinating, but also useful. Such products can be used as a gift to a memorable event or, for example, to give a zest to your own along by wearing a bracelet made of beads and lace. Weaving bracelets from laces is so interesting that it can take you not for one evening.

In addition to the laces themselves, ribbons, beads, sequins, beads, etc. can be added as a supplement.

Ways of weaving bracelets from laces

There is a huge number of ways how you can braid a bracelet from a lace. Here are just a few of them:

Single puzzle

This is a way of classic plaiting braids.

1. Crop one edge of a leather lace.
2. We make the notation of the slits and cut them with a knife.
3. Cut off the second edge of the bracelet.
4. We begin the weaving. Mentally we number the cords from left to right.
5. The first cycle: between the first and second lace we pass the third.
6. The bottom of the weave between the first and second.
7. Next, do the second to the first, third to the second.
8. The bottom of the weave is between the second and third.
9. Then we begin to weave the second cycle in the same way.
10. We continue the weaving until the string ends.
11. Evenly distribute the weave by hand and install the rivet.

Double Puzzle

This technique is performed by analogy with a single puzzle, with the only difference being that six strips are used here. Or you can take three bands, divide each into three branches and weave them with the technique of a single puzzle. In this case, each band is taken as one.

Maiden spit

The weaving scheme of the three shoelaces is shown in the photo below.

A braid of four cords

This scheme is woven as follows: the fifth cord on the second, the first on the third, the fourth on the second and the first.

Circumferential braiding

In addition to the usual lace, you will also need a thin rope of a different color than the main lace.

1. We glue together the ends of the laces and ropes. We are wrapped in a string.
2. We divide the cords into right and left pairs.
3. We begin to weave. We hold the first cord for the rope, we pass between the third and fourth. We lay it on the third cord.
4. The fourth cord is held behind a rope, we pass between the second and a rope. We lay it on the first cord.
5. Next, the plait according to the scheme: the leftmost cord - under the rightmost, the rightmost cord - under the leftmost.

How to weave bracelets from laces with your own hands?

Most often, a wax cord is used to create the bracelet.

1. We take two cords, add them and tie them in a knot.
2. Technology of weaving is always the same:
3. - from right to left: above the cord - under the string - over the cord;
4. - on the left on the right the opposite: under the string - on the cord - under the cord.
5. We continue to weave from right to left.
6. The pattern will begin to appear.
7. For the convenience of weaving, you can attach one end of the bracelet to a book, table or any other solid surface. For fixing we use scotch tape.
8. We tie the ends of the laces together.
9. Fold the bracelet in half.
10. A long piece of lace must be threaded into the knot, from which we started our weaving. So, a big circle should turn out.
11. Once again, put the circle in half.
12. A long lace is put into the circle of weaving. The bracelet is ready.

When putting on such a braided bracelet on hand, the long part of the lace should be tightened to such an extent that the bracelet tightly lays on the wrist.

Braided bracelets from laces and macrame will look beautiful on a woman's hand, and complement not only the evening dress, but also casual clothing. And also you can make bracelets from other materials: fabric , leather or lightning . The process of creating such ornaments will make it possible to realize your creative potential and the most vivid imaginations.