Rose from SHDM

Balloons have become a permanent attribute of the holidays. And many figures have already been invented, what can be done from them. In this article, you will learn how to step-by-step make a rose from the simulation balls (SDM). It should be noted that every time before the ball is twisted, it must be crushed by hand, so that it becomes softer and the air moves to the end.

Master class for making roses from ShDM

It will take:

• two spheres 260 (5 cm x 150 cm);
• a green ball 260 (5 cm x 150 cm) or 160 (2.5 cm x 150 cm);
• scissors;
• pump.

1. We pump the first ball, leaving about 10 cm not inflated.
2. Starting from the node, we twist a chain of two bubbles 3-4 cm in size.
3. We twist the base of the 2nd bubble and knot together into the lock.
4. Two bubbles are scrolled around the axis so that they have a position like in the photo.
5. We twist the third bubble a little smaller than the previous ones.
6. Make 2 twists to make parts 4 and 5, 25 cm long.
7. We connect the end of part 5 and the end of bubble 3 by scrolling a couple of times.
8. Separate on the continuation of the ball 6 piece length of 25 cm, and fix its end between 4-5 parts.
9. We fasten together the end of the 3rd bubble and the beginning of the 7th.
10. We get three petals, which are scrolled around the axis, positioning them, as shown in the figure.
11. Bubble 4 is pushed in half by 5, swapping the adjacent petal bases.
12. Similarly, put the bubble 5 in the center of the 6th part, and then the part 6 into the hole of the part 4.
13. It should look like this:
14. For the third row of petals, we inflate the second ball, leaving the tail 3-4 cm.
15. The ball is folded 3 times, in the bend places we separate the bubbles and twist them together.
16. On the billet of the rose below we twist a small bubble (7), the remaining end is the 8th part. We fix the end of the bubble 7 between the petals of the second ball.
17. The end of the 8 ball is cut off, the bubble is blown off and fixed by twisting with petals.
18. We pump the green ball, leaving the tail 8 cm. We make a small green ball on the end, and with it we connect the stem with the last row of the flower.
19. Similarly to items 11, 12, 13 we make the third row of rose petals.
20. On the leg we twist a bubble 7 cm long.
21. We make leaves on the stem, using the scheme described in paragraphs 6,7,8,9,10. The result should be:
22. We spread the petals and the middle of the rose, we shape the leaves, and our rose is ready.

Rose-made roses from balls can be used alone or in a bouquet. And children probably like a dog from balls .